Effect of amorphous silica and silica sand on removal of chromium(VI) by zero-valent iron

The effect of two surfaces (amorphous silica and silica sand) on the reduction of chromium(VI) by zero-valent iron (Fe(0)) was investigated using batch reactors. The amendment of both surfaces significantly increased the rate and extent of Cr(VI) removal. The rate enhancement by amended surfaces is presumed to result from scavenging of Fe(0)-Cr(VI) reaction products by the provided surfaces, which minimized surface deactivation of Fe(0). The rate enhancing effect was greater for silica compared to sand, and the difference is attributed to silica's higher surface area, greater affinity for reaction products and pH buffering effect. For a given mass of Fe(0), the reactivity and longevity of Fe(0) to treat Cr(VI) increased with increasing dose of silica. Elemental analyses of the reacted iron and silica revealed that chromium removed from the solution was associated with both surfaces, with its mass distribution being approximately 1:1 per mass of iron and silica. The overall result suggests reductive precipitation was a predominant Cr(VI) removal pathway, which involves initial reduction of Cr(VI) to Cr(III), followed by formation of Cr(III)/Fe(III) hydroxides precipitates.     

Performance of an electrochemical COD (chemical oxygen demand) sensor with an electrode-surface grinding unit

An electrochemical COD (chemical oxygen demand) sensor using an electrode-surface grinding unit was investigated. The electrolyzing (oxidizing) action of copper on an organic species was used as the basis of the COD measuring sensor. Using a simple three-electrode cell and a surface grinding unit, the organic species is activated by the catalytic action of copper and oxidized at a working electrode, poised at a positive potential. When synthetic wastewater was fed into the system, the measured Coulombic yields were found to be dependent on the COD of the synthetic wastewater. A linear correlation between the Coulombic yields and the COD of the synthetic wastewater was established (10-1000 mg L(-1)) when the electrode-surface grinding procedure was activated briefly at 8 h intervals. When various kinds of wastewater samples obtained from various sewage treatment plants were measured, linear correlations (r(2)> or = 0.92) between the measured EOD (electrochemical oxygen demand) value and COD of the samples were observed. At a practical wastewater treatment plant, the measurement system was successfully operated with high accuracy and good stability over 3 months. These experimental results show that the application of the measurement system would be a rapid and practical method for the determination of COD in water industries.     

Wastewater treatment plants (WWTPs) as a source of sediment contamination by toxic organic pollutants and fecal sterols in a semi-enclosed bay in Korea

Toxic organic contaminants and a macrobenthic community were assayed in sediments collected near a wastewater treatment plant (WWTP) outfall to assess the impact of WWTP discharges on an aquatic environment. Average concentrations of toxic organic contaminants in sediments from 20 locations were 96.7ng TEQ/kg dry matter for PCDD/Fs, 1.84ng TEQ/kg dry matter for dioxin-like PCBs, 29.1microg/kg dry matter for PBDEs, 411microg/kg dry matter for nonylphenols, 1021microg/kg dry matter for fecal sterols, and 928microg/kg dry matter for PAHs. Concentrations of all the organic contaminants and fecal sterols varied widely and there was a clear decrease in concentration gradients with increasing distances from the WWTP outfall. This result suggests that WWTP activities contribute to contamination by organic chemicals. A survey of benthic organisms showed the dominance of a few polychaete species, indicating a deterioration of the macrobenthic community by the WWTP discharge. Non-parametric multidimensional scaling (MDS) ordination and Spearman correlation analyses showed that organic contamination is associated with the benthic community structure. For polychaete species, the sensitive species for organic contaminants was Paraprionospio pinnata, while contaminant-tolerant species were Spiochaetopterus koreana and Capitella capitata. BIOENV analyses of all locations suggested PCDDs and PCDFs as the major contaminants influencing the structure of the macrobenthic community. The present study highlights that continuous WWTP discharges contribute to severe organic contamination and risks for the benthic community in an aquatic ecosystem.     

Absorption characteristics of new solvent based on a blend of AMP and 1,8-diamino-p-menthane for CO2 absorption

Aqueous 1,8-diamino-p-menthane (KIER-C3) and commercially available amine solutions were tested for CO₂ absorption. A 2-amino- 2-methyl-1-propanol (AMP) solution with an addition of KIER-C3 showed 9.3% and 31.6% higher absorption rate for CO₂ than the AMP solution with an addition of monoethanolamine (MEA) and ammonia (NH₃), respectively. The reaction rate constant for CO₂ absorption by the AMP/KIER-C3 solution was determined by the following equation: k_2,AMP/C3 = 7.702×10⁶ exp (-2248.03/T). A CO₂ loading ratio of the AMP/KIER-C3 solution was also 2 and 3.4-times higher than that of the AMP/NH3 solution and the AMP/MEA solution, respectively. Based on the experimental results, KIER-C3 may be used as an excellent additive to increase CO₂ absorption capability of AMP.     

Enhancement of turbulent scalar mixing and its application by a multihole nozzle in selective catalytic reduction of NOx

The mixing characteristics of a passive scalar in the turbulent flow of a selective catalytic reduction process were numerically and experimentally investigated, focusing especially on an injection nozzle with multiple holes for the reducing agent. The multihole injection nozzle studied has six holes that are perpendicular to the ambient flue gas flow and are located near the tip of the nozzle. Large eddy simulation was applied to the turbulent flow and mixing fields to elucidate the mixing mechanism of the proposed nozzle compared with the single-hole nozzle that is commonly used in the conventional selective catalytic reduction process. From the results, there exist broader regions of higher turbulent intensities for the multihole nozzle than for the conventional single-hole nozzle. These regions are well matched with the positions of high vorticity in the near upstream region of the jet flow issuing from the multiple holes of the nozzle. Consequently, the high turbulent intensities and vorticity magnitudes lead to intensified mixing between the flue gas and the reducing agent. Hence, the most suitable molar ratio between NOx and the reducing agent for the catalytic reaction can be easily obtained within a shorter physical mixing length as a result of the enhanced scalar mixing. Finally, the numerical results were applied to a trial design version of a multihole nozzle, and this nozzle was experimentally tested to confirm its mixing performance.     

The exceedance patterns of air quality criteria: a case study of ozone and nitrogen dioxide in Seoul, Korea between 1990 and 2000

In this study, the environmental behavior of two major airborne pollutants, ozone and nitrogen dioxide, was investigated with respect to their exceedance patterns of air quality criteria. For this purpose, we used data sets collected from a total of 31 air quality monitoring stations dispersed across the Seoul metropolitan city between 1990 and 2000. In the case of NO(2), the frequency of hourly exceedance data sets exhibited little changes in the early 90s. However, it increased dramatically after 1995, probably in compliance with a rapid increase in the total number of automobiles. Likewise, the daily exceedance of O(3) in the early 90s was not significant, approaching 100 cases (except in 1994). However, its total quantity began to surpass 300 cases since around 1996. Comparison of those exceedance data was also made among spatially divided data groups. In the case of NO(2), the occurrence of exceedance data was dominated by the western part of the city in both magnitude and frequency. On the other hand, that for O(3) was characterized by notably strong occurrences in the eastern counterpart. The overall results of our analysis of the NO(2) and O(3) exceedance data sets indicate an inextricable linkage between the two pollutants in association with geographical and meteorological factors.     

Distribution characteristics of polychlorinated biphenyls in crucian carp (Carassius auratus) from major rivers in Korea

Polychlorinated biphenyls (PCBs) levels in crucian carp were determined at 20 locations along four major river systems, several small-scale rivers and a wetland in Korea. Twenty-eight congeners, ranging from tri- to hepta-CBs were detected. A gas chromatograph with a mass selective detector was used to quantify the individual PCB congeners. The objectives of this study were to investigate the levels of contamination of PCBs in freshwater fish and to observe the pattern of their distribution. The sampling locations were chosen among 31 sampling sites that are currently used as environmental residue checkpoints by the Korean Ministry of Environment. Concentrations of individual congeners ranged from not detectable (n.d.) to 0.75 ng g(-1) on a wet weight basis. The total concentrations of PCBs at each site ranged from n.d. to 5.41 ng g(-1) of wet weight. The most heavily contaminated site was the Nakdong estuary located near the Shinpyung-Janglim factory district. The PCB 153 and 138 were the principal congeners and penta- and hexa-chlorinated biphenyls comprised the main congener groups.     

Changes in air saturation and air-water interfacial area during surfactant-enhanced air sparging in saturated sand

Reduction in the surface tension of groundwater, prior to air sparging for removal of volatile organic contaminant from aquifer, can greatly enhance the air content and the extent of influence when air sparging is implemented. However, detailed information on the functional relationship between water saturation, air-water contact area induced by air sparging and the surface tension of water has not been available. In this study, the influence of adding water-soluble anionic surfactant (sodium dodecyl benzene sulfonate) into groundwater before air sparging on the air-water interfacial area and water saturation was investigated using a laboratory-scale sand packed column. It was found that water saturation decreases with decreasing surface tension of water until it reaches a point where this trend is reversed so that water saturation increases with further decrease in the surface tension. The lowest water saturation of 0.58 was achieved at a surface tension of 45.4 dyn/cm, which is considered as the optimum surface tension for maximum de-saturation for the initially water-saturated sand used in this study. The air-water contact area generated in the sand column due to air sparging was measured using a gaseous interfacial tracer, n-decane, and was found to monotonically increase with decreasing water saturation. The results of this study provide useful design information for surfactant-enhanced air sparging removal of volatile contaminants from aquifers.     

The effect of emergent macrophytes on the dynamics of sulfur species and trace metals in wetland sediments

This study focuses on the effect of plants on the biogeochemistry of sulfur species and the mobility of heavy metals in wetland sediments. Results showed that, in the presence of plants, sediments had elevated sulfate concentrations in the rhizosphere during the growing season, ranging from 0.2 to 6.20 mmol L(-1), whereas only a small difference in the sulfate profiles between vegetated and non-vegetated sediments was observed during senescence. Based on the sulfate concentration increase, the oxygen release rate from the roots to achieve the corresponding oxidation of sulfide was estimated as 0.85 g m(-2) day(-1). Evapotranspiration-induced advection is a major contributor to the transport of sulfate from the water column into the sediments, and also allows dissolved trace metals (i.e. Cd, Pb, and Zn) to be transported into the sediments and react with the acid volatile sulfide pool, resulting in the immobilization of trace metals in these sediments.     

Compositional data analysis and geochemical modeling of CO2–water–rock interactions in three provinces of Korea

Environmental Geochemistry and Health - The CO2-rich spring water (CSW) occurring naturally in three provinces, Kangwon (KW), Chungbuk (CB), and Gyeongbuk (GB) of South Korea was classified based...